It won't have any effect on performance but you can try and push it into the center a little bit by loosening off the action screws and pushing it to the opposite side and then retightening them down. “Alright, on the Howa 1500 this can come up from time to time. I send MDT an email with pics and their answer was not exactly confidence inspiring.here is their response in entirety So a closer inspection and more measurements show me that the chassis fore end is not aligned with the barrel by a fair margin and is actually twisted (see pics) It appears as if the MDT chassis is not as precision as they reckon - in fact, I think I might shoot the retailer an email see what they say. So even using a rest, I simply could not get the chassis vertical and zero’d when compared to scope mounts - I put meter onto mounts and it would be zero, then onto chassis and it would be 2.5 + degrees out.so there was no way I could get reticle aligned. I’ve just been through a bit of an ordeal and thought I’d ask how others do it - and shine a light on some mistakes I made.įitting a new scope to my mdt chassis / howa and I attempted to get the vertical reticle in the scope aligned with a window frame which should be vertical.
#Mdt chassis clearance mod#
Some examples would be the Magpul MOE-K / MIAD, standard AR-15 mil-spec unit or the BCM Mod 0.So I ve edited this topic based on the fact, that all the issues I was encountering was attributable to the fore end problems with the MDT chassis. Note : AR-15 grip used with these chassis MUST be without the beavertail. Not included with the chassis : TUF-22 rifle, AR-15 buffer tube, castle nut, butt stock or pistol grip. Included with the chassis : the rear hold down block and screws as well as a pistol grip screw and a receiver take down screw. (Some may be tight while others are loose.) We will however guarantee that our DAR-22 & TUF-22 (and the TX versions of each) will fit and function perfectly.
While most other brands of 10/22 platform rifle will *most likely* fit into these chassis, we cannot guarantee they will have the correct tolerances due to different manufactures’ quality control limits. Positive grip point for your fore hand or use as a barricade rest Multiple M-LOK attachment points for versatility of mounting bi-pods or other accessories Properly angled butt stock hole to allow for better cheek weld with an optic It doesn’t get better than this for the 10/22 platform rifle Pre-fit with a rear hold down block which attaches to the rear of all TUF-22 receivers and hold the action rock steady for consistent shooting accuracy. Pre-inlet to accept our TUF-22TX barreled actions with the front barrel cinch nut Closely machined tolerances to fit our TUF-22 barreled actions perfectly Expertly machined from a single piece of aluminum with a host of features to make your DAR-22 / TUF-22 as accurate as possible given the limitations of the. Our Dlask Arms design team spent some time with the MDT CADD department to develop a chassis we are both very proud of.
They are here ! Our collaboration with MDT has come to fruition and the end result is spectacular ! MDT Precision Chassis for DAR-22 / TUF-22
0 kommentar(er)
